On this page
Thornton's roofing rules at a glance
| Topic | Rule |
|---|---|
| Permit trigger | Permit when more than 1 square (100 sq ft) is replaced; 1 square or less is a repair |
| Slopes | Once a permit is required, every slope with damaged shingles is replaced in its entirety; no partial asphalt replacement on a slope |
| Inspections | Sheathing (if installed), mid-roof by texted photos and a virtual final inspection (since 28 Aug 2025) |
| Ice barrier | Not required unless the shingle manufacturer's instructions specify it |
| Mixed coverings | Allowed if the different types meet at a ridge, hip or open valley |
| Multi-unit buildings | One application per building; each individually addressed unit listed |
The whole-slope rule
Thornton's whole-slope rule changes the size of a job. The city's Roofing Standards say that when a permit is required, "each slope containing damaged shingles shall be replaced in its entirety," and partial replacement of asphalt roofing on a single slope is not allowed. No other city in our five-city comparison writes it this way.
Different roof coverings may sit side by side only where they meet at a ridge, hip or open valley, so a slope cannot be half one shingle and half another.
Photo mid-roof and video final
- Permit issuedInspections can only be scheduled after issue, through the portal, by 3:30 pm the prior business day.
- SheathingAny new roof sheathing is inspected before it is covered.
- Mid-roof photosOld covering off, drip edge and valley flashing on, 75–100% of felt and 40–75% of shingles installed.
- Virtual finalBy FaceTime or Google Meet; shingles self-sealed and all flashing complete.
An inspector contacts the onsite contact by text or call between 8 and 9 a.m. on the inspection day. If the inspector cannot complete a virtual inspection, for example because of a poor signal, it may be rescheduled or done in person.
The photo checklist
Thornton's mid-roof photo set must clearly show:
- The address numbers on the house
- An approved underlayment
- Roof valley materials
- The starter course
- Metal flashing
- The nail pattern: 6 nails per shingle
- The shingle wrapper, matching the shingles on the permit application
Ask your roofer to send you the same photos. They are the only record of what is under your shingles, and they are useful for the next insurance claim or a home sale.
Approved shingles and wind warranty
The standards list approved shingle lines by manufacturer. Shingles not on the list need approval before the permit is issued, and the division will consider any shingle that carries a national wind warranty of 80 mph sustained or 90 mph 3-second gust. The standards also warn that some manufacturers require a warranty upgrade to be covered for the stated wind speed. Ask your roofer which warranty tier the quote includes; the warranty guide explains the difference.
Ice barrier and drip edge
Ice and water shield is not required unless the shingle manufacturer's installation instructions specify it. Drip edge flashing is required at the eaves and along the rakes and must extend over the sheathing at the fascia. Maximum sheathing spacing follows the manufacturer's instructions. The standards also recommend having a licensed plumbing or mechanical contractor check dryer and gas vent connections below the roof line after a reroof, because the city does not inspect them.
What changed since 2018
The city still hosts its 2018 roofing guide, so both versions turn up in searches. The current standards (last update 12 September 2025) differ:
| Topic | 2018 guide | 2025 standards |
|---|---|---|
| Permit trigger | Less than 1 square is a repair | 1 square or less is a repair; more needs a permit |
| Six nails | Required 15 Sept to 15 Apr | Six-nail pattern shown in the mid-roof photo set |
| Inspections | No photo or virtual process described | Texted photos (mid-roof), video call (final) |
Sources: City of Thornton, Roofing and Reroofing guide (last update 25 Sept 2018, superseded); City of Thornton Building Inspection Division, Roofing Standards (last update 9-12-25). Both read 2026-10-20.
Hail in Adams County
Thornton is in Adams County, which logged 141 hail reports in NOAA's Storm Events Database for 2016–2025, including 34 in 2023. The 2023 metro maximum, a 2.75-inch stone, was reported near Strasburg in Adams County on 10 May 2023. Reports are county-level, not Thornton-only.
Show the data as a table
| Year | Reports |
|---|---|
| 2016 | 8 |
| 2017 | 6 |
| 2018 | 18 |
| 2019 | 12 |
| 2020 | 6 |
| 2021 | 16 |
| 2022 | 0 |
| 2023 | 34 |
| 2024 | 29 |
| 2025 | 12 |
Counted by us from the NOAA NCEI Storm Events details files, retrieved 2026-10-20. Method on Denver metro hail history.
What to ask a roofer in Thornton
- Does the quote replace every damaged slope in full, as the standards require once a permit is needed?
- Is the shingle on the city's approved list, or will you get approval before the permit?
- Which wind-warranty tier is included, and is an upgrade needed for the stated wind speed?
- Will you send me the mid-roof photos and attend the virtual final?
- Who will check the dryer and gas vent connections after the reroof?
Put the answers in the written contract required by C.R.S. 6-22-103.
Common questions
Do I need a permit to replace shingles in Thornton?
Only if more than 1 square (100 sq ft) of roof covering is replaced. One square or less counts as a repair and needs no permit.
Can I replace just the damaged part of a slope in Thornton?
Not once a permit is required. Thornton's Roofing Standards say each slope containing damaged shingles shall be replaced in its entirety; partial replacement of asphalt roof covering on a single slope is not allowed.
How does Thornton inspect roofs?
Since 28 August 2025, mid-roof inspections are done by texting photos and final inspections are virtual, by FaceTime or Google Meet. A sheathing inspection applies where new sheathing is installed.
Does Thornton require ice and water shield?
Not unless the shingle manufacturer's installation instructions specify it. Drip edge is required at the eaves and rakes.