Skip to content

Permits, compared from official sources

Roof permits in the Denver metro, city by city

Every Denver-metro city requires a permit for a full roof replacement, but the line for repairs is different in each one. Denver's guideline triggers a permit above 10% of the roof; Littleton at 1 square (100 sq ft) in aggregate; Thornton above 1 square; Centennial and Lakewood exempt only repairs under 100 sq ft. Inspections, ice-barrier rules and who may pull the permit also differ, which is why the address, not the roofer's office, decides the rules.

Five cities, each cell taken from the city's own handout or web page and read on 2026-10-20. Denver's newest residential roofing guideline is dated 2015, so its cells are marked verify.

An independent publisher, not a roofing contractor. Facts last checked . How we source.

On this page
  1. The rules side by side
  2. When a repair needs a permit
  3. Inspections, by city
  4. Ice barrier: the rule that flips
  5. Who may pull the permit
  6. Permit checker
  7. Why Denver's rules are marked verify
  8. Cities not in the table yet
  9. What to ask your roofer
  10. Common questions

The rules side by side

Denver-metro permit rules differ on four points: the repair threshold, inspections, ice barrier and who may pull the permit. No city publishes a comparison, and the permit aggregators we checked repeat one city's text for its neighbors. Each column comes from one document, linked under the table. "Not stated" means the document we read does not address it; it does not mean there is no rule.

Residential reroof rules in five Denver-metro cities (read 2026-10-20)
CityPermit triggerInspectionsIce barrierContractor credential
Denver
City and County of Denver
Permit once work exceeds 10% of the roof area Not stated in the 2015 guideline we could read Not required at eaves (2015 guideline) Denver contractor license plus a Specialty Class D supervisor certificate (Community Planning and Development)
Littleton
Arapahoe, Jefferson and Douglas counties
Permit for 1 square (100 sq ft) or more in aggregate; up to 100 sq ft in any 365 days is a repair Mid-roof inspection at 25–75% of covering installed with all underlayment and flashing in place; pre-roof inspections no longer required Required: ASTM D1970 ice barrier at least 2 ft inside the exterior wall line at the eaves of all conditioned structures Valid City of Littleton contractor license required (class not named in the policy)
Centennial
Arapahoe County
Repairs under 100 sq ft need no permit; repairs over 25% of the roof area require a full tear-off and reroof Mid-roof inspection on every reroof permit (tear-off done, underlayment complete, 25–75% of new material on) Required on all roofs Not stated in this document
Lakewood
Jefferson County
Permit for reroofs and repairs; repairs under 100 sq ft are exempt Photo inspections uploaded to eTRAKiT; no mid-roof inspection for asphalt shingles Not required (metal drip edge required at eaves; asphalt reroofs need it at eaves and rakes) Lakewood contractor registration of class 5h or higher
Thornton
Adams County
Permit when more than 1 square (100 sq ft) is replaced; 1 square or less is a repair Sheathing (if installed), mid-roof by texted photos and a virtual final inspection (since 28 Aug 2025) Not required unless the shingle manufacturer's instructions specify it Not stated in this document

Two rows stand out. Thornton is the only city that forces a whole slope to be replaced once a permit is needed, which turns a "patch the hail hits" quote into a slope-by-slope quote. Centennial is the only one that says a repair over a quarter of the roof becomes a full reroof. Both rules change what an insurance scope should say, so they matter before the adjuster visits, not after.

When a repair needs a permit

Most homeowners only meet the permit question on a repair: a few blown-off shingles, a valley, a hail-cracked slope. The thresholds are written three different ways, and the difference matters on a typical 2,000–3,000 sq ft roof.

A percentage of the roof (Denver)

Denver's 2015 Residential Roofing Guidelines require a permit when repairs exceed 10% of the roof's square footage. On a 2,400 sq ft roof that is 240 sq ft, about two and a half squares. A percentage rule is generous on big roofs and strict on small ones.

A fixed area (Littleton, Thornton, Centennial, Lakewood)

The suburbs use 100 sq ft, one roofing square, but read the wording. Littleton's Policy 20-005 requires a permit at 1 square or more in aggregate, and counts anything up to 100 sq ft in any 365 days as a repair, so three small repairs in a year can add up to a permit. Thornton's standards require one when more than 1 square is replaced. Centennial and Lakewood exempt repairs under 100 sq ft.

Rules that enlarge the job

  • Thornton: once a permit is required, "each slope containing damaged shingles shall be replaced in its entirety"; partial asphalt replacement on one slope is not allowed.
  • Centennial: repairs over 25% of the roof area require a full tear-off and reroof.
  • Denver: two layers of roofing at most, so a roof that already has two layers cannot be overlaid; it comes off to the deck.
Use it in the claimIf your adjuster prices a partial-slope repair on a Thornton house, or a repair over 25% of a Centennial roof, quote the city rule back with the link. The scope has to produce work the city will pass.

Inspections, by city

A permit is only as good as its inspections, and the cities now run them very differently. Several have moved to photos and video since the pandemic.

  1. Permit issuedPulled by the roofer (or owner, where allowed) before work starts.
  2. Tear-offOld layers off; deck exposed. Littleton and Thornton inspect new sheathing.
  3. Mid-roofUnderlayment and flashing done, part of the covering on. Littleton: 25–75%. Thornton: 40–75% of shingles.
  4. Covering finishedShingles sealed, flashing complete, vents reconnected.
  5. FinalIn person, by photo or by video call, depending on the city.
  • Littleton: mid-roof inspection with 25–75% of the covering installed and all underlayment and flashing in place. Pre-roof inspections are no longer required.
  • Centennial: a mid-roof inspection on every reroof permit. Miss it and the city wants photos with a waiver, a partial tear-off, or an engineer's letter.
  • Lakewood: photo inspections uploaded to eTRAKiT, and no mid-roof inspection for asphalt shingles.
  • Thornton: since 28 August 2025, mid-roof inspections are by texted photos and finals are by FaceTime or Google Meet. The photo set must show the address, underlayment, valleys, starter course, flashing, the six-nail pattern and the shingle wrapper.

For the day-by-day sequence on a full job, see what to expect during a roof replacement. Thornton's photo list doubles as a homeowner checklist anywhere in the metro: ask your roofer for the same photos, dated, whatever city you are in.

Ice barrier: the rule that flips across a city line

Ice barrier, the self-adhering membrane laid at the eaves to stop meltwater backing up under shingles, is where neighboring cities disagree most plainly.

Ice barrier requirement by city
CityIce barrier at eaves
DenverNot required. at eaves (2015 guideline)
LittletonRequired. ASTM D1970 ice barrier at least 2 ft inside the exterior wall line at the eaves of all conditioned structures
CentennialRequired. on all roofs
LakewoodNot required. (metal drip edge required at eaves; asphalt reroofs need it at eaves and rakes)
ThorntonNot required. unless the shingle manufacturer's instructions specify it

"Not required" is a code minimum, not advice. Many shingle makers require ice barrier for their warranty, and Thornton's standard defers to the manufacturer for that reason. On north-facing eaves that hold snow, read the shingle's installation instructions before you accept a quote that omits it. The ice-dam guide covers why it forms.

Who may pull the permit

Colorado does not license roofers at the state level, so each city decides who may pull a roofing permit. Denver licenses roofers through Community Planning and Development: a Specialty Class D supervisor certificate plus the contractor license it qualifies. The certificate needs two years of field experience (24 projects in 24 separate months), no exam, and renews every three years.

  • Littleton: starting work without a valid Littleton contractor license, or without a permit, adds an investigative fee equal to the permit cost.
  • Lakewood: hired roofers need a Lakewood contractor registration of class 5h or higher; owners doing the work themselves may pull a permit for their own owner-occupied home.
  • Aurora: a Roofing Contractor license requires ICC roofing certification; Aurora is not in the table because we have not yet read its reroof standard.

The full comparison of license classes is on roofing licenses in the Denver metro.

Permit checker

Enter the area to be replaced and the checker applies the city's written threshold. A standalone version is at Do I need a roof permit?

Do I need a roof permit?

Pick the city that issues permits for the address (not the mailing city) and describe the job. The answer quotes that city's own document and links it.

–

Rules change. The permit office for your address has the final word; this tool is re-checked against the source documents each quarter.

Why Denver's rules are marked verify

The newest residential roofing guideline Denver publishes is dated 2015. Treat the wind-zone figures as historical until CPD confirms them under the 2025 Denver Building Code. The guideline cites the 2009 IRC with Denver's 2011 amendments. It sets shingle wind ratings by street centerline (90 mph at Federal Boulevard, 100 mph at Sheridan Boulevard and 110 mph at Kipling Street) and requires modified rolled roofing or an EPDM-type membrane on slopes under 1:12. Denver has since adopted a 2025 building code, which raised the residential ground snow load from 35 to 43 psf, so some of the 2015 detail may have moved.

Until Community Planning and Development publishes a newer roofing guideline, ask the permit desk or your roofer which wind rating the current code requires at your address, and get it written on the contract.

Sources: City and County of Denver, Residential Roofing Guidelines (rev. 28 Aug 2015); City and County of Denver, Community Planning and Development, "Snow Load Changes: 2025 DBC, 2024 IBC/IRC, ASCE 7-22". Read 2026-10-20 and 2026-09-23.

Cities not in the table yet

We add a city only after reading its own roofing rules. These are close but not there:

  • Aurora: Aurora licenses roofing contractors (ICC roofing certification, $120 supervisor fee plus $150 license fee), but we have not read a city reroof standard yet. Source.
  • Castle Rock: The town's Re-Roof Checklist blocks automated reading, so its tear-off and permit-expiry rules are unconfirmed. Source.
  • Boulder: Boulder County requires Class A roofs in wildfire zones; City of Boulder rules not yet verified. Source.

For Arvada, Westminster, Broomfield, Parker, Englewood and the rest, call the building division for the address. The service-area page lists what we know for each.

What to ask your roofer about the permit

  • Which city issues the permit for this address, and under whose license or registration?
  • What is the permit number, and when will it be issued? (Look it up yourself on the city portal.)
  • Which inspections will the city do, and will you send me the photos you submit?
  • Does the quote include ice barrier, and if not, does the shingle maker's warranty allow that?
  • Is the permit fee in the price, and will the final invoice show the closed permit?

Put the answers in the written contract that C.R.S. 6-22-103 already requires. A roofer who suggests skipping the permit to save money is also skipping the only independent check on the work.

Common questions

Do I need a permit to replace my roof in the Denver metro?

Yes. Every city in our table requires a permit for a full reroof. The cities differ on small repairs: Denver's guideline sets the line at 10% of the roof, Littleton at 1 square (100 sq ft) in aggregate, Thornton at more than 1 square, and Centennial and Lakewood exempt repairs under 100 sq ft.

Who pulls the roofing permit, me or the roofer?

Normally the licensed or registered roofer, under its own city license. Lakewood's 2026 handout also lets a homeowner pull a permit for their own owner-occupied home. Ask for the permit number before the tear-off starts and look it up on the city portal.

Is ice and water shield required on Denver-area roofs?

It depends on the city. Centennial requires an ice barrier on all roofs and Littleton requires an ASTM D1970 ice barrier at the eaves of conditioned buildings. Lakewood and Denver's 2015 guideline do not require it, and Thornton requires it only where the shingle maker's instructions call for it.

What happens if a roofer skips the mid-roof inspection?

In Centennial, a missed mid-roof inspection has to be cleared with photos and a waiver, a partial tear-off or an engineer letter, and a re-inspection fee may apply. In Littleton, starting without a permit adds an investigative fee equal to the permit cost. Either way, it is your house that carries the unclosed permit.

How much is a roof permit in Denver?

We have not found a published flat fee. Lakewood requires the permit valuation to include all labor and materials. Denver roofers' own cost pages quote $100–$500 for the permit line, but those are contractors' figures, not the city's fee schedule.

Get roofing quotes in the Denver metro

Free and no obligation. Tell us the job and ZIP; we check whether a partner roofer covers it before passing anything on.

Enter a Denver-metro ZIP (800–804). Outside that, we do not have a partner yet.
Please add your name.
A phone number is how the roofer reaches you.
Please add a working email.
Please add the street address for the job.
Get roofing quotes