On this page
Replace or repair?
Replacement is the right call when the problem is the whole roof rather than one spot: widespread hail bruising, shingles that have lost their granules across several slopes, a deck that is soft in more than one place, or a roof that already has two layers. Repair makes sense for a single flashing failure, a few blown-off shingles or a cracked pipe boot on an otherwise sound roof. Our roof repair guide covers the repair side, including when a repair itself needs a permit.
Two city rules can make that decision for you. Thornton's roofing standards say that once a permit is required, "each slope containing damaged shingles shall be replaced in its entirety", and Centennial requires a full tear-off and reroof when repairs exceed 25% of the roof area. In those cities a large "repair" is legally a replacement of the affected slopes or the whole roof.
Sources: City of Thornton Building Inspection Division, Roofing Standards (last update 9-12-25); City of Centennial Building Division, Residential Roof Repairs and Re-Roofing. Read 2026-10-20.
| What you see | Usually points to |
|---|---|
| Hail bruises or cracks on most slopes | Replacement (and an insurance inspection first) |
| Two existing layers of shingles | Replacement: Denver allows no third layer |
| Granule loss and curling across the roof | Replacement |
| One leaking pipe boot, vent or flashing | Repair |
| A few shingles lifted by wind on one slope | Repair (check the city threshold; in Thornton the whole slope if a permit is needed) |
The Denver replacement sequence
Most replacements follow the same order. The city inspections are what differ, and they decide how long the roof sits half-finished.
- Written scope and contractSigned by both sides before work, with the terms C.R.S. 6-22-103 lists.
- PermitPulled by the licensed roofer from the city the house is in.
- Tear-off and deck checkOld layers off; damaged or gapped decking replaced or overlaid.
- Underlayment, flashing, coveringMid-roof inspection where the city requires one.
- Final inspection and close-outPermit closed, warranty papers and invoice handed over.
Tear-off is the only time anyone sees the deck. Littleton requires a panel overlay where spaced-board gaps exceed half an inch, and Denver's 2025 code raised the ground snow load from 35 to 43 psf, which is why decking and its fastening get attention on a replacement. The step-by-step version, with what each city inspects, is in what to expect during a roof replacement.
Sources: City and County of Denver, Community Planning and Development, "Snow Load Changes: 2025 DBC, 2024 IBC/IRC, ASCE 7-22", read 2026-09-23; Littleton Policy #20-005, read 2026-10-20.
Permit and layer rules
Denver's Residential Roofing Guidelines require a building permit once repairs exceed 10% of the roof's square footage, and allow two layers of roofing at most; anything more means tearing off to the deck. The suburbs set their own lines, summarized here and compared in full in the permits guide.
| City | Permit trigger | Tear-off or slope rule |
|---|---|---|
| Denver | Permit once work exceeds 10% of the roof area | Two layers maximum; a third means tear-off to the deck |
| Littleton | Permit for 1 square (100 sq ft) or more in aggregate; up to 100 sq ft in any 365 days is a repair | Spaced-board decks with gaps over 1/2 in need a 3/8 in (minimum) panel overlay and a sheathing-nailing inspection |
| Centennial | Repairs under 100 sq ft need no permit; repairs over 25% of the roof area require a full tear-off and reroof | Replacement removes all layers to the deck |
| Lakewood | Permit for reroofs and repairs; repairs under 100 sq ft are exempt | Existing roof coverings on dwellings and accessory buildings must be removed to the deck |
| Thornton | Permit when more than 1 square (100 sq ft) is replaced; 1 square or less is a repair | Once a permit is required, every slope with damaged shingles is replaced in its entirety; no partial asphalt replacement on a slope |
Each row from that city's document as linked in the permits guide; read 2026-10-20. Denver's guideline is dated 2015 and marked verify.
Wind ratings by street
Denver's guideline sets the minimum shingle wind rating by how far west the house sits, measured at street centerlines: 90 mph at Federal Boulevard, 100 mph at Sheridan Boulevard and 110 mph at Kipling Street, tested to ASTM D7158 or D3161. West of Denver the foothill winds are stronger, which is the logic of the gradient.
Show the data as a table
| Street centerline | Minimum rating |
|---|---|
| Federal Blvd | 90 mph |
| Sheridan Blvd | 100 mph |
| Kipling St | 110 mph |
Source: City and County of Denver, Residential Roofing Guidelines (rev. 28 Aug 2015), read 2026-10-20. Historical figures; confirm the current requirement with Denver CPD.
Every architectural shingle on the market carries a wind rating on the wrapper. Ask the roofer to write the rating and test standard on the contract, and check it against what the city requires for your address. The wind damage guide explains what the ratings mean.
What a Denver roof replacement costs
Roofers price by the square, 100 square feet of roof surface. Across the named Denver sources, published installed bands run $400–$730 a square for asphalt, $550–$1,150 for Class 4 impact-resistant shingles and $700–$2,300 for metal.
Show the data as a table
| Material | Low | High |
|---|---|---|
| Asphalt / architectural | $400 | $730 |
| Class 4 impact-resistant | $550 | $1,150 |
| Metal | $700 | $2,300 |
Lowest low and highest high across 3 Denver sources that price per square: Core Roofing Systems (Denver metro); Gates Roofing (Denver); Road Home Exteriors (Denver metro and Front Range). Read 2026-09-23.
Totals for a whole house range from $9,000 to $28,000 across 4 sources. Gates Roofing puts tear-off and disposal at $1,000–$2,500 and the permit at $100–$500; Road Home Exteriors puts a 2,000–2,500 sq ft home at $15,000–$22,000. These are the companies' own published figures, not ours, and our own Denver quote index will not publish a figure until it holds at least 12 dated quotes per cell.
Colorado sales tax falls on materials, not on labor stated separately on the bid. In a lump-sum quote the contractor has built the tax into the price, so a lump-sum and an itemized quote can be the same money presented two ways.
Sources: the four Denver cost sources listed in the cost guide; Colorado Department of Revenue, "Sales 6: Contractors and Retailer-Contractors" (03/2020).
Shingle, Class 4 or metal
Most Denver replacements are architectural asphalt. The usual upgrade after a hail claim is a Class 4 impact-resistant shingle, the top rating in UL 2218. Class 4 is the top rating in UL 2218, the impact test in which a two-inch steel ball is dropped onto the material from twenty feet. Colorado law does not require insurers to give a premium credit for it; the Division of Insurance advises asking your own insurer whether a hail-resistant roof earns a discount. Get the credit in writing from your carrier before you pay the upgrade, and ask whether your policy has a cosmetic-damage exclusion.
Metal (standing seam or stone-coated steel) costs roughly two to three times asphalt per square in the published bands and needs snow retention designed in. Check your HOA covenants before you choose a material; Colorado law limits what an HOA can require only on fire safety. See Class 4 shingles, metal roofing and materials for Colorado hail.
The contract Colorado requires
Colorado's residential roofing law applies to roofing contracts over $1,000 on homes, not to new construction. Before any roofing work begins, the roofer must give the owner a written contract signed by both parties, stating: the scope of work and materials; approximate dates; the approximate cost based on the damage known at signing; the roofer's physical address, email and phone; its surety and liability insurer, if any; its cancellation and deposit-refund policy, including full refund of a deposit if the owner rescinds within 72 hours of signing; the owner's rescission right under 6-22-104; and, when insurance pays, that the roofer cannot pay, waive or rebate the deductible.
- Scope of work and named materials (shingle line, wind rating, underlayment, ice barrier)
- Approximate dates and approximate cost
- Physical address, email and phone of the roofer
- Surety and liability insurer
- 72-hour cancellation with full deposit refund
- Your right to rescind within 72 hours of a written claim denial
- In bold: payments held in trust until materials arrive or most work is done
- If insurance pays: the roofer cannot pay, waive or rebate the deductible
Sources: C.R.S. 6-22-103, Contracts for roofing services; C.R.S. 6-22-102, Definitions. Read 2026-10-20.
The full plain-English walk-through is on Colorado roofing contract law. Licensing is separate: Colorado has no state roofing license, so check the roofer on the register of the city the house is in (license guide).
When hail pays for it
Many Denver replacements are insurance jobs. Our count of NOAA storm reports for the seven metro counties found 869 hail events from 2016 to 2025, 96% of them between May and August. If hail is the reason you are replacing, get the inspection and the written scope before you sign, and read hail damage roof repair.
Where the contract is paid from insurance proceeds, the owner may rescind, in whole or in part, within 72 hours after receiving the insurer's written notice that the claim is denied. Supplemental work that was reasonably foreseeable at signing is not a ground. Notice goes to the roofer's physical address. The roofer must return payments within 10 days, keeping only the value of work actually performed in a workmanlike manner.
Sources: NOAA NCEI Storm Events, counted 2026-10-20; C.R.S. 6-22-104, Rescission.
Common questions
How long does a roof replacement take in Denver?
The roofing itself on a typical single-family house is usually one to three working days. The calendar time is longer: the permit has to be issued first, and suburbs such as Littleton, Centennial and Thornton require a mid-roof inspection before the roof can be closed. Ask your roofer for the full timeline including inspections.
Can a new roof go over the old one in Denver?
Only if the house has one layer now. Denver's residential roofing guideline allows two layers at most, so a roof that already has two must be torn off to the deck. Centennial requires replacement to remove all layers to the deck regardless.
Do I need a permit to replace my roof?
Yes, in every metro city we have checked. The roofer normally pulls it under its city license. Ask for the permit number before tear-off and check it on the city portal.
How much does a roof replacement cost in Denver?
Published 2026 Denver figures for a single-family replacement run from about $9,000 to $28,000 installed across 4 named sources. These are third-party published ranges, not our quotes; see the cost guide for every source and date.
Can a roofer pay my insurance deductible?
No. C.R.S. 6-22-105 bars a roofer paid from insurance proceeds from paying, waiving or rebating any part of your deductible, or advertising that it will.