On this page
Denver's wind zones, street by street
Denver is one of the few places where the required shingle wind rating changes inside the city. Its residential roofing guideline sets the rating by street centerline, increasing toward the foothills, where downslope winds are strongest.
Show the data as a table
| Location | Rating |
|---|---|
| Federal Blvd centerline | 90 mph |
| Sheridan Blvd centerline | 100 mph |
| Kipling St centerline | 110 mph |
Source: City and County of Denver, Residential Roofing Guidelines (rev. 28 Aug 2015), read 2026-10-20. Marked verify: the guideline predates Denver's 2025 code.
Shingle wind rating by street centerline: 90 mph at Federal Blvd, 100 mph at Sheridan Blvd, 110 mph at Kipling St (ASTM D7158 or D3161). Slopes under 1:12 need modified rolled roofing or an EPDM-type membrane.
The suburbs set wind performance differently. Thornton's Roofing Standards list approved shingle lines and accept others that carry a national wind warranty of 80 mph sustained or 90 mph 3-second gust, with prior approval. Littleton's Policy 20-005 sets a minimum of six nails per asphalt shingle.
Sources: City and County of Denver, Residential Roofing Guidelines (rev. 28 Aug 2015); City of Thornton Building Inspection Division, Roofing Standards (last update 9-12-25); Littleton Policy 20-005.
Reading a shingle wind rating
Two wind tests appear on shingle wrappers. ASTM D3161 (fan-induced) Class A, D and F correspond to 60, 90 and 110 mph. ASTM D7158 (uplift) Class D, G and H correspond to 90, 120 and 150 mph basic wind speed on the older ASCE 7-05 basis (about 115, 150 and 190 mph ultimate under ASCE 7-10).
| Test | Class | Rating | What it measures |
|---|---|---|---|
| ASTM D3161 | A / D / F | 60 / 90 / 110 mph | Fan-induced wind across the shingle |
| ASTM D7158 | D / G / H | 90 / 120 / 150 mph | Uplift on a sealed shingle (basic wind speed, ASCE 7-05 basis; about 115 / 150 / 190 mph ultimate under ASCE 7-10) |
Source: Professional Roofing (NRCA), wind resistance classifications for asphalt shingles, read 2026-10-20.
Manufacturer warranties add a third number, and it is often conditional. CertainTeed, for example, lists a 15-year 110 mph wind warranty on its Landmark shingle, with an upgrade to 160 mph available only when its own starter and hip-and-ridge products are used. Thornton's standards warn that "some manufacturers require that a warranty upgrade be purchased in order to be covered for the stated wind speed." So the rating that protects you is the one your installation actually qualifies for.
Sources: CertainTeed, Landmark shingle product page; Thornton Roofing Standards. Read 2026-10-20 (CertainTeed 2026-11-16).
How wind damages a roof
- LiftGusts lift the lower edge of a shingle, starting at edges, rakes and ridges where wind accelerates.
- UnsealThe adhesive strip lets go. Cold, dusty or aged sealant fails sooner.
- Crease or tearThe tab flexes above the nails and creases, tears, or pulls over the nail heads.
- PeelA missing shingle exposes its neighbors' edges, and the damage spreads across the slope.
That sequence is why nailing and sealing matter more than shingle weight. A shingle nailed too high, with too few nails, or installed in cold weather that never fully sealed, behaves like an unsealed shingle in the first strong wind.
Spotting wind damage
Start from the ground with binoculars or a phone camera zoom. Do not go on the roof; leave close inspection to a professional with fall protection.
- Missing shingles or tabs, often on rakes, eaves and near the ridge.
- Horizontal creases a few inches above the shingle's lower edge.
- Shingles that sit raised or wavy, or tabs flapping in moderate wind.
- Lifted or missing ridge caps and hip caps.
- Bent drip edge or flashing, and shingle pieces in the yard or gutters.
- New stains on ceilings or in the attic after the storm.
The first 48 hours
- Photograph every slope you can see from the ground, debris in the yard, and any interior damage, with dates.
- Stop water getting in. Emergency tarping is reasonable mitigation, but keep the receipt and photos of what was tarped.
- Find your declarations page and check the wind and hail deductible before you ask anyone for a claim estimate.
- Get a written scope of the damage from an inspection, slope by slope.
- Be wary of door-knockers. See storm chasers and roofing scams.
Repair or replace a wind-damaged slope
A few missing tabs on a younger roof are normally a repair. Whether that repair needs a permit, and how much of the roof it has to include, depends on the city.
| City | Permit trigger | Rule that can enlarge the job |
|---|---|---|
| Denver | Permit once work exceeds 10% of the roof area | Two layers maximum; a third means tear-off to the deck |
| Littleton | Permit for 1 square (100 sq ft) or more in aggregate; up to 100 sq ft in any 365 days is a repair | — |
| Centennial | Repairs under 100 sq ft need no permit; repairs over 25% of the roof area require a full tear-off and reroof | Repairs over 25% of the roof require a full tear-off and reroof |
| Lakewood | Permit for reroofs and repairs; repairs under 100 sq ft are exempt | — |
| Thornton | Permit when more than 1 square (100 sq ft) is replaced; 1 square or less is a repair | Once a permit is required, every slope with damaged shingles is replaced in its entirety; no partial asphalt replacement on a slope |
Two other factors push toward replacement: brittle older shingles that crack when a roofer lifts them to make a repair, and a discontinued color that will not match. Matching is a policy and case-law question in Colorado rather than a statutory one, so ask the adjuster how your policy treats it.
Details by city are in the permit comparison, and the roof repair guide covers repair scope.
Wind claims
The Colorado Division of Insurance says wind and hail deductibles are often a percentage of coverage (1, 2 or 5 percent), so nothing is paid if the damage is below that amount; asks homeowners to request an itemized settlement and the exact policy language in any dispute; notes that supplements are possible and that public adjusters are licensed and optional; and suggests asking your insurer about discounts for hail-resistant roofs.
Source: Colorado Division of Insurance, consumer advisory: tips after hailstorms, read 2026-10-20.
Two Colorado roofing-law rules apply to any insurance-paid roof job. A roofer paid from property-insurance proceeds may not advertise or promise to pay, waive or rebate all or part of an insurance deductible. If it does, the insurer need not consider the roofer's estimate, and the owner or insurer may sue for damages. And the written contract must exist before work starts, with the terms set out in C.R.S. 6-22-103. Use the deductible calculator to see what a percentage deductible means in dollars before you decide whether to file.
Sources: C.R.S. 6-22-105, Deductibles; C.R.S. 6-22-103, Contracts for roofing services. General information, not insurance or legal advice.
Lowering the risk on the next roof
- Match the rating to the location. On the west side of the metro, ask which ASTM class the shingle carries and what wind speed the current code requires at your address.
- Buy the accessories the rating depends on. If the higher wind tier needs specified starter strips and hip-and-ridge caps, they should be line items on the quote.
- Nailing. Six nails per shingle is the rule in Littleton and part of Thornton's photo inspection. Ask for it in writing elsewhere.
- Edges. Drip edge at eaves and rakes is required in Thornton and Lakewood; it also protects the deck edge where wind starts lifting.
- Season. Shingles installed late in the year may not seal until warmer weather; ask how the roofer handles cold-weather installs.
The architectural vs 3-tab comparison covers how shingle types differ on wind class.
Common questions
What wind speed should shingles be rated for in Denver?
Denver's 2015 residential roofing guideline set ratings by street centerline: 90 mph at Federal Boulevard, 100 mph at Sheridan Boulevard and 110 mph at Kipling Street, rising to the west. That guideline predates Denver's 2025 code, so confirm the current requirement with Community Planning and Development before you sign.
What is the difference between ASTM D3161 and D7158?
They are two different wind tests. D3161 uses a fan and rates shingles Class A, D or F (60, 90 or 110 mph). D7158 measures uplift and rates them Class D, G or H (90, 120 or 150 mph basic wind speed on the older ASCE 7-05 basis).
Are creased shingles wind damage?
Often, yes. A shingle lifted by wind can bend back along a line above the nails and stay creased even after it lays flat again. Creased shingles have lost their seal and are more likely to blow off next time, so photograph them for the record.
Does homeowner insurance cover wind damage to a roof?
Wind is usually a covered peril, but Colorado policies often carry a separate wind and hail deductible that can be a percentage of the dwelling coverage. The Colorado Division of Insurance notes that nothing is paid if the damage is below the deductible.
Can a roofer cover my deductible on a wind claim?
No. C.R.S. 6-22-105 bars a roofer paid from insurance proceeds from promising to pay, waive or rebate any part of your deductible, and the contract must say so.